Cutting

<1>ASK glass-magnesium boards can be cut manually with common flady saws or handsaws. They can also be cut ou shaped by electric circular dentate saws or curvilinear saws.If board thickness is less than 10mm,a cutting blade can be used. <2>Do not drill holes and cutouts on the board less than 10mm from the edge. <3>Board joint filler methods   Apply adequate joint compound into joints about 3mm(0.12inch)in width.   Use a joint knife {50mm(1.97inch)in size} to bury punched tapes into joints. Seal the surface completely by joint compound. ?   Sand the joint surface gently after the joint filler is completely cured/dried.Apply a second layer lf joint filler with a larger joint knife{200mm(7.88inch)in width}.   Sand the joint sur face gently again after the joint filler is completely cure/dried.The wall panel is now ready for plaster or paint according to the specified surface requiremints.